20 shop online at store.biohorizons.com IMPLANT TRANSFER When seating the implant, use the corresponding dimples on the driver to orient one internal hex flat perpendicular to the implant angulation plane. Doing so verifies that an angled abutment will correct the angulation. Place the apex of the implant into the osteotomy and begin rotating slowly. PEEK snap ring driver hex To pick-up the implant, align the driver hex with the implant hex and press firmly to engage the PEEK snap ring. hex flat dimple If too much resistance is felt during insertion, reverse the implant to relieve pressure and re-insert into the osteotomy. If the final drill was not used while preparing the osteotomy, remove the implant and revise the osteotomy with the final drill.
RkJQdWJsaXNoZXIy MTE0MzMw