14 shop online at store.biohorizons.com Important Considerations • Peri-operative oral rinses with a 0.12% Chlorhexidine Digluconate solution have been shown to significantly lower the incidence of post-implantation infectious complications.2 A pre-operative 30-second rinse is recommended, followed by twice daily rinses for two weeks following surgery. • Drilling must be done under a constant stream of sterile irrigation. A pumping motion should be employed to prevent over-heating the bone. Surgical drills should be replaced when they are worn, dull, corroded or in any way compromised. BioHorizons recommends replacing drills after 12 to 20 osteotomies.3 A Drill-usage Tracking Chart is available at biohorizons.com to record this important information. • There is a risk of injury to the mandibular nerve associated with surgical drilling in posterior mandibular regions. To minimize the risk of nerve injury, it is imperative that the clinician understands the virtual treatment plan created and ensures the surgical guide corresponds to the clinician’s virtual treatment plan. Surgical Manual Guided Surgery Case Example Placing a 5.8mm x 7.5mm Tapered Short Implant A patient-specific surgical protocol should be included with the surgical guide. The surgical protocol includes the recommended components to be used for each implant site. Verify the protocol corresponds to the submitted virtual treatment plan prior to surgery. Clinician judgment must always supersede any recommendations in the surgical protocol and any BioHorizons Instructions for Use. 2300 Riverchase Center • Birmingham, Alabama 35244 • corporate: 866.872.9785 or 205.967.7880 • fax: 205.870.0304 BioHorizons products are available in 90 countries throughout the world • www.biohorizons.com Sample Protocol for BioHorizons Tapered Short Guided Surgery Kit implant label 28 29 implant type TSL4607 TSL5807 implant length 7.5mm 7.5mm guide site Complete Complete implant site preparation drill #1 (2.5mm) #1 (2.5mm) drill #2 (3.2mm) #2 (3.2mm) drill #3 (3.7mm) #3 (4.7mm) drill DB (4.1mm) DB (5.4mm) guided implant placement implant driver 4.6 x 7.5 5.8 x 7.5
RkJQdWJsaXNoZXIy MTE0MzMw