24 shop online at store.biohorizons.com Implant level with osseous crest. Seat drill to the first line. FINAL BONE PREPARATION & DRIVERS Place into the osteotomy, apply firm apical pressure and rotate slowly in a clockwise direction. When the threads engage, allow the tap to feed without excessive pressure. To remove, rotate the bone tap in a counter-clockwise direction, allowing it to back out of the osteotomy. Do not pull on the bone tap to remove it from the site. Purpose: Remove cortical bone at ridge crest for pressure-free seating of the implant collar. • Use when dense cortical bone is present at crest • Rounded non-end cutting hub centers drill in osteotomy • Use following the final width increasing drill for each implant • Color-coded by implant body diameter (gray=3.0mm, purple=3.4mm, yellow=3.8mm, green=4.6mm and blue=5.8mm) • 1,000 RPM Purpose: Prepare dense cortical bone for implant threads. • Site specific • Final instrument prior to implant placement • Can be driven with a handpiece, ratchet or hand wrench • Color-coded by implant body diameter (gray=3.0mm, purple=3.4mm, yellow=3.8mm, green=4.6mm and blue=5.8mm) • 30 rpm or less15 Purpose: Engage the implant’s internal hex/abutment internal square to drive implants into the osteotomy • Implant level drivers are color-coded by prosthetic connection: • gray=3.0mm platform • yellow/green=3.5/4.5mm platform • blue=5.7mm platform • 30 rpm or less15
RkJQdWJsaXNoZXIy MTE0MzMw